Cig-Arrete* Standalone Alarms

CSA-GDT Standalone Cig-Arrete* Smoke Detector

SPECIAL PRICE - ONE ONLY - WAS £137.21

The stand alone detector with tone sounder does not require any additional products.
The module is designed for single applications and only requires the insertion of 4 x AA size batteries or alternatively 1 x 9V PP3 battery.
The module is fixed to the ceiling of the area to be protected by 2 screws and quite simply monitors the environment from this point on.
Coverage area approx 3m x 3m x 3m
* Registered Trademark

Features...

Price:
£68.60
£82.32 Including VAT at 20%

CSA-GDV Standalone Cig-Arrete* Smoke Detector

SPECIAL PRICE - ONE ONLY - WAS £140.00

The stand alone cigarette smoke detector with integral voice sounder does not require any additional products.
The module is designed for single applications and only requires the insertion of 4 x AA size batteries or alternatively 1 x 9V PP3 battery.
The module is fixed to the ceiling of the area to be protected by 2 screws and quite simply monitors the environment from this point on.
Coverage area approx 3m x 3m x 3m
* Registered Trademark

Features...

Price:
£70.00
£84.00 Including VAT at 20%

Daughter Board CSA-DBD
For Standalone Cig-Arrete* CSA-GDT & CSA-GDV

The Cig-Arrête* Daughter Board Module is designed only for use with the Cig-Arrête* Stand Alone Module (part no CSA-GDV or CSA-GDT).

The module is designed to allow control of external equipment via a volt-free (clean) contact and to power the CSA-GDV and CSA-GDT from an external supply.
In addition it facilitates connection of the CSA-GDV and CSA-GDT to a Cig-Arrête* Controller.

* Registered Trademark

Specification

Local power input: 6-12V dc (regulated)
Current <600mA in alarm condition

Alarm Outputs:

1a: Voltage free, single pole changeover contact 1A: 30v dc, or
1b: 470-Ohm resistor switched across C and N/O terminal (remove shorting link underneath PCB)
2: To hardwire CSA-S5B or CSA-S5R controller for repeat indication

Price:
£37.38
£44.86 Including VAT at 20%

CSA-CSBB Cig-Arrete Battery Operated Combined Sounder / Beacon
The Cig-Arrête Combined Sounder Beacon provides both
a visual and audible indication that an alarm has been
generated by the Cig-Arrête System.
The unit is powered via 2 x PP3 alkaline batteries each
providing 9V dc (18V dc in total) and is normally used as
part of the Cig-Arrête Master/Slave System.

Price:
£50.00
£60.00 Including VAT at 20%